Code CR1200 Quick Start User Manual download pdf

CR1200/CR1210’s unique targeting function uses two converging targeting LEDs to guide

the user to optimal reading range.

Too far from code

Too close to code

Optimal distance from code is

3.8” (9.7 cm) for the CR1200.

Optimal from code is 2.3” (5.8 cm)

for the CR 1210.

Targeting

Should you need to change a cable on the CR1200/CR1210, rst, unscrew

the two screws in the cable clip (Figure 2). Slide the cable clip away from the reader

(Figure 3). A spacer was placed between the cable clip and the reader handle. Be sure to

remove and keep track of the spacer. Remove the cable from the reader by pulling back

on the 8-pin DIN connector (Figure 4).

Changing or Adding Cables

Figure 2

Figure 3

Figure 4

Figure 5 Figure 6

Attach the new cable by sliding the cable clip onto the cable (Figure 5) and then sliding it

up to the end of the cable. Snap the spacer onto the end of the cable (Figure 6). Align

the 8-pin DIN connectors. Firmly press the cable (with cable clip and spacer) into the

bottom of the reader handle (Figure 7). Place and secure the screws into the cable clip

attachment alternating between the right and left screw until fully seated. Screws shall be

tightened to a torque setting of 1 inch-lbs. Note: Do not over-torque screws.

Figure 7

CR1200/CR1210’s unique targeting function uses two converging targeting LEDs to guide

the user to optimal reading range.

Too far from code

Too close to code

Optimal distance from code is

3.8” (9.7 cm) for the CR1200.

Optimal from code is 2.3” (5.8 cm)

for the CR 1210.

Targeting

Should you need to change a cable on the CR1200/CR1210, rst, unscrew

the two screws in the cable clip (Figure 2). Slide the cable clip away from the reader

(Figure 3). A spacer was placed between the cable clip and the reader handle. Be sure to

remove and keep track of the spacer. Remove the cable from the reader by pulling back

on the 8-pin DIN connector (Figure 4).

Changing or Adding Cables

Figure 2

Figure 3

Figure 4

Figure 5 Figure 6

Attach the new cable by sliding the cable clip onto the cable (Figure 5) and then sliding it

up to the end of the cable. Snap the spacer onto the end of the cable (Figure 6). Align

the 8-pin DIN connectors. Firmly press the cable (with cable clip and spacer) into the

bottom of the reader handle (Figure 7). Place and secure the screws into the cable clip

attachment alternating between the right and left screw until fully seated. Screws shall be

tightened to a torque setting of 1 inch-lbs. Note: Do not over-torque screws.

Figure 7

© 2012 Code Corporation. All rights reserved. www.codecorp.com

© 2012 Code Corporation. All rights reserved. www.codecorp.com

1 2

Summary of Contents

Page 1 - Changing or Adding Cables

CR1200/CR1210’s unique targeting function uses two converging targeting LEDs to guide the user to optimal reading range.Too far from codeToo close to

Page 2 - Code Reader™ 1200/1210

Quickstart GuideCode Reader™ 1200/1210C003527_04_CR1200_Quickstart The Code Reader 1200 (CR1200) and Code Reader 1210 (CR1210)are shipped with the

Comments to this Manuals

No comments