D013597_02_CR3600_User_Manual
24.0 - CR3600 DPM
DPM (Direct Part Marks such as Dot Peen and Laser-Etched) reading is enabled by default in CR3600 DPM readers.
Dot Peen and Laser-Etched Reading
Dot Peen and Laser-Etched reading is the default DPM seng. This will also read common 1D/2D printed barcodes.
Dot Peen Barcode Reading
If reading Dot Peen barcodes only, scan the DPM (Dot Peen Only) On conguraon barcode to opmize reading for that barcode
type. Scanning the DPM (Dot Peen Only) On conguraon barcode will disable laser-etched barcode reading. This will not read
common 1D/2D printed barcodes.
Laser-Etched Barcode Reading
If reading laser-etched barcodes only, scan the DPM (Laser-Etched only) On conguraon barcode to opmize laser-etched barcode
reading. Scanning the DPM (Laser-Etched Only) On conguraon barcode will disable Dot Peen barcode reading. This will also read
common 1D/2D printed barcodes.
DPM (All) O
To reset a CR3600 DPM reader to standard CR3600 sengs, scan the DPM (All) O conguraon barcode. This will disable all DPM
reading. To return to DPM reading funconality, scan the preferred DPM On conguraon barcode.
DPM (Dot Peen and Laser-Etched) On
DPM (Dot Peen Only) On
DPM (Laser-Etched Only) On
DPM (All) O
CR3600 DPM Targeng
The opmal reading distance between reader and barcode varies based on barcode type and quality. Typical reading distance is
from 2 inches (50mm) to 4 inches (100mm). To improve reading performance for dot peen (and other) marks, lt the reader 10 to 45
degrees from vercal so that it is not perpendicular to the barcode.
12
Comments to this Manuals