C004387_07_CR3500_User_Manual - 14
Save Settings
1.9 - Bluetooth Radio Operaon
1.9.1 - Introducon
The CR3500 features a Bluetooth® wireless radio. The radio allows for point-to-point wireless communicaon with other Bluetooth
devices that support serial port protocol (SPP). If keyboard entry is necessary, CodeXML® Router will need to be installed. The following
guide will give you general instrucons on connecng your CR3500 to a desktop or laptop computer with a Bluetooth radio.
Connecng With A QuickConnect Code
The easiest way to connect to a Bluetooth device is to visit the Code website and create a QuickConnect Code that is specic to
your device (Figure 1.21). This code will link your CR3500 directly to the desired Bluetooth device. To create a QuickConnect Code,
you will need to know the Bluetooth address (oen referred to as the BD_ADDR) of that device. You can usually nd the 12-character
Bluetooth address somewhere on the device near the device’s serial number (see Figure 1.22).
If you purchased a CodeXML® Bluetooth Modem or a Belkin® Bluetooth adapter from Code or from an authorized distributor, a
QuickConnect Code was included. If you bought a Bluetooth adapter separately and wish to create a QuickConnect Code, please visit
Code’s web site at: hp://www.codecorp.com/bdaddr.php.
Important Note: You will need to locate the Communicaons (COM) Port assigned to the Bluetooth serial port protocol. While
installing the Bluetooth Conguraon Manager Soware that was included with your Bluetooth adapter, make sure to note the
Communicaons (COM) Port number the soware assigned for the adapter (e.g., COM 10). This is the COM Port through which the
CR3500 will connect.
To connect your reader, use the following steps:
1. Power on the CR3500 reader by pressing one of the red buons for one second to power on the reader.
2. Scan the Reset to RF Factory Defaults Code (M684_01).
3. Scan the Quick Connect Code you receieved or created from Code’s website.
4. The CR3500 will automacally connect to the computer. By default, the CR3500 will beep once aer it connects
and beep four mes in a row if it did not connect.
5. Scan the Save Sengs Code (M188_02) if you want to save the wireless connecon sengs to the CR3500 so
that the CR3500 will automacally try to connect wirelessly the next me it is powered on.
Example:
Reset to RF Factory Defaults QuickConnect Save Sengs
Figure 1.21
Figure 1.22
Comments to this Manuals